Motorola P40 image renders shows off 6.2-inch display, punched-hole surface
Motorola P40 is expected to roughly measure 160.1 x 71.2 x 8.7mm, and thickness might be about 10mm.


Leaked image renders of Motorola P40. Image: 91mobiles[/caption]The Moto P40 is said to sport a 6.2-inch display with thin, no notch, just a punched hole, thin bezels on the sides and a relatively thicker bezel on the bottom with the branding on it.As for dimensions, the Motorola P40 is expected to roughly measure 160.1 x 71.2 x 8.7mm, and the thickness will be about 10mm if the protruding rear camera bump in added to it.The left side of the phone's frame seen with the SIM tray, and the volume and power buttons are placed on the right.The bottom frame consists of USB Type-C port, a speaker grille, and a hole for the mic. The top frame shows a hole for the 3.5mm headphone jack.The renders show the back of the phone to have rounded edges with some shading on them, making them seem darker than the rest of the backside.The back of the phone also seems to be made of glass as the renders show the back to be reflective.The camera setup is placed on the left side on the back. It is vertically aligned with dual cameras. The report states that the primary sensor might carry a 48 MP lens, but the resolution of the second sensor is still unknown.There are two LED flash units placed below the camera set up.There is also a fingerprint sensor embedded in the Motorola logo and at the bottom of the rear casing, there is an Android One logo.There are no details on the hardware specs or the pricing of the phone yet.

Why AI notetakers are raising serious privacy and security concerns
China's low-cost AI models are changing the global AI race. Here's why Silicon Valley is worried
China's Kimi K3 challenges US AI leaders with frontier-level performance at lower cost
How did Instagram run ads promoting child abuse in India?
Why has India halted WhatsApp’s username feature before launch?
